www.amico.com 15
Monitor Shelf: Philips Intellivue
WARNING:
ENSURE THE MOUNTING SHELF IS FIRMLY LOCKED AND HORIZONTAL TO PREVENT THE MONITOR
FROM SLIDING AND FALLING.
NOTE:
Philips recommends a Maximum tilt of 15°.
NOTE:
It is recommend to use M6 x 20 mm screws with thread locker or patched screws in order to eliminate
possible dangers.
1. Attach the table top mount from Philips (not supplied by Amico) to the mounting shelf by securing the 3 screws
through the shelf
(Figure 2)
.
2. Place the monitor to the table top mount until it clicks
(Figure 3)
.
3. Tilt the monitor to the desired angle and re-adjust the tension as needed with a 12 mm wrench
(Figure 4)
.
Philips Table Top Mount
(not supplied)
12 mm hex nut
To tighten
To loosen
Three 20 mm
M6 screws
Table top
mount
Mounting shelf
Figure 1
Figure 2
Figure 3
Figure 4
Section 3: Installation to Monitor and Accessory
