www.amico.com 23
Portrait and Landscape Limiter
NOTE:
Lock-out feature only available for monitors using VESA adapters
NOTE:
Lock-out is useful for shorter cables. It prohibits the rotation of the monitor to +/- 15°.
1. Remove the monitor by removing the four VESA 75 screws (or VESA 100 users, the inner screws that holds the VESA
100 adapter to the VESA 75 adapter) Loosen the rotation tension bolt approximately 1 full turn at the center of the
VESA adapter and rotate the VESA head to locate the VESA rotation stoppers on the two sides of the built in stopper
(Figure 1)
2. Re-mount the monitor (refer to page 13). Grab the monitor itself and turn to desired angle. The head will stop at the
location of the stopper and prohibit further movement
(Figure 2 and 3)
.
Section 4: Adjustments
Figure 1
Figure 2
Figure 3
Rotational
Tension Bolt
VESA Rotation
Stopper
Built in Stopper
VESA Rotation
Stopper
Built in
Stopper
Height Locking Lever Adjustments
WARNING:
THE HEIGHT LOCKING LEVER MUST BE INSTALLED PROPERLY BEFORE MOUNTING THE AHM ARM TO
THE RAIL OR MOUNTING THE DISPLAY TO THE AHM ARM.
NOTE:
The height locking lever is designed to stop all vertical movement of the AHM arm when it is in use. Loosen
the lever to adjust the AHM arm vertically, and tighten when finished to lock the AHM arm.
1. Insert the height locking lever into the mounting hole on the side of the arm. Turn the lever clockwise to lock
vertical movement, or turn the lever counterclockwise to release the vertical lock. Check to make sure the arm is
locked in its highest position before mounting the arm into the channel
(Figure 1 and 2)
.
Height Locking Lever:
Rotate Counter-Clockwise to Release
Rotate Clockwise to Lock
Figure 1
Figure 2
