www.amico.com 7
Section 2: Installation on Rail Systems
Mounting to the Monitor Rail System (MRS) with the MON-Adapter
WARNING:
NEVER ATTEMPT TO MOUNT OR REMOVE THE ARM
FROM THE RAIL WHEN A MONITOR IS INSTALLED
WARNING:
TO PREVENT THE ADAPTER FROM FALLING DOWN
THE CHANNEL, ENSURE THAT THE FOUR SET SCREWS ARE
FASTENED TO THE TIGHTEST POSSIBLE POSITION
(FIGURE 1)
.
NOTE:
For safety, top and bottom stoppers prevent the adapter
from sliding out of the MRS. To remove, the adapter must be
taken out from the top of the rail with the top stopper pressed
back into the rail
(Figure 2)
.
1. With the AHM arm locked in the highest vertical position, support
the bottom of the arm and guide the MON-channel adapter into
the top of the wall channel.
2. Once the arm is at the desired height, tighten all four screws on
the MON-channel adapter using a 1/8" (3 mm) hex key
(Figure 1)
.
Figure 2
Bottom
Stopper
Top Stopper
MRS Rail: Length for representational use only
Figure 1
Standard
MON-Adapter
1/8" (3 mm)
set screws
MRS Rail
OSHPD Anchor Pre-Approval OPA-1743
In compliance with standards established for the anchor and installation of instrument support systems by the
California Office of Statewide Health Planning and Development (OSHPD), Amico Accessories Inc. has obtained
preapproval for MRS 19" (48.26 cm) Wall Channels or longer with extension arm. For proper installation requirements
please refer to our OPA Document.
