www.amico.com 9
Section 2: Installation on Rail Systems
Mounting to the VRS (Vertical Rail System)and the Ohmeda Rail
WARNING:
Both adapters must be sitting in the rail securely.
WARNING:
To prevent the adapter from falling down the channel ensure that the screw knobs are fastened to the
tightest possible position. After the installation, rotate the AHM arm side to side to verify that no movement is
present between the adapters and the rail.
WARNING:
Please be sure to fasten the nuts to the screw knobs since screw knobs alone are not safe to hold the
weight of the monitor
(Figure 3 and 6)
.
NOTE:
On the side of the V-adapter and the D-adapter there are screw knobs that lock the adapter into the rail
once secured. When you turn the knob counter-clockwise the side of the adapter moves outwards, putting the
adapter into an unlocked position
(Figure 1 and 4)
. When the knob is turned clock-wise the side of the adapter
moves inwards, putting the adapter into a locked position
(Figures 2 and 5)
.
V-adapter for the VRS: Sliver adapter
(Figure 1 to 3)
.
D-adapter for the Ohmeda rail: Black adapter
(Figure 4 to 6)
.
Figure 1
Screw knob
Slide inwards
Locked
Figure 4
Screw knob
Slide inwards
Locked
Figure 2
Screw knob
Slide outwards
Unlocked
Figure 5
Screw knob
Slide outwards
Unlocked
Figure 3
Opposite side of the V-adapter
Figure 6
Opposite side of the V-adapter
