Annunciator Module
Noise Level Control
Factory Default: 80 Decibels
To decrease noise level:
1. Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
Control of Remote Alarm Buzzer
Factory Default: Normal Condition
To silence remote alarm buzzer when silencing the annunciator module:
1. Locate jumper at J6. Move jumper to:
NORM =
Remote alarm buzzer will silence when annunciator module is silenced.
ALRM =
Remote alarm will not silence when annunciator module is silenced.
The buzzer will only silence when an alarm condition has been cleared.
Please refer to Appendix B.
1. Turn on Alarm
2. Set switches #8 and #10 the OFF position
3. Set switches #5 and #6 the ON position
4. The display will show the current reading of the pressure
5. Adjust the calibration, using the “UP” and “DOWN” push buttons, to the desired value.
6. Set switches #5 and #6 the OFF position
7. Turn on #10 if AIMS is connected (do not turn on #8)
When you have completed step #7, the display module will automatically go into “RESET” mode. This will store
the data that you entered.
Steps to Re-Calibrate the Sensor from Area Module v4.0
A m i c o M i c r o p r o c e s s o r B a s e d A l a r m
P a g e : 1 6
FIELD ADJUSTMENTS
THE ANNUNCIATOR MODULE
NOISE LEVEL CONTROL
Factory Default: 90 Decibles
To decrease noise level:
1.
Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
CONTROL OF REMOTE ALARM BUZZER
Factory Default: Normal Condition
To silence remote alarm buzzer when silencing the
annunciator module:
1.
Locate jumper at J6. Move jumper to:
NORM =
Remote alarm buzzer will silence when annunciator
module is silenced.
ALRM =
Remote alarm will not silence when annunciator
module is silenced. The buzzer will only silence
when alarm condition has been cleared. Please
refer to Appendix B.
J6
TEST
ALRM
NORM
SILENCE
LVL1
LVL2
LVL3
J5
A m i c o M i c r o p r o c e s s o r B a s e d A l a r m
P a g e : 1 6
FIELD ADJUSTMENTS
THE ANNUNCIATOR MODULE
NOISE LEVEL CONTROL
Factory Default: 90 Decibles
To decrease noise level:
1.
Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
CONTROL OF REMOTE ALARM BUZZER
Factory Default: Normal Condition
To silence remote alarm buzzer when silencing the
annunciator module:
1.
Locate jumper at J6. Move jumper to:
NORM =
Remote alarm buzzer will silence when annunciator
module is silenced.
ALRM =
Remote alarm will not silence when annunciator
module is silenced. The buzzer will only silence
when alarm condition has been cleared. Please
refer to Appendix B.
J6
TEST
ALRM
NORM
SILENCE
LVL1
LVL2
LVL3
J5
12
Amico Corporation
