4 Amico Corporation
User Responsibility
The information contained in this Installation, Operation and Maintenance Manual pertains only to the Alert-4
microprocessor based digital LCD Alarm. This product will perform as described in this manual when assembled,
operated, maintained and serviced in accordance with the installation instructions provided.
The alarm must be checked periodically. Parts that are broken, missing, worn, distorted or contaminated must be
replaced immediately. Should such repair or replacement become necessary, please contact Amico Corporation or their
distributors.
All alarms should not be repaired or altered without prior written or verbal approval from Amico Corporation or its
distributors. Failure to comply will void all warranty on the alarm.
Statements in this manual preceded by the words WARNING, CAUTION, DANGER and NOTE are of special significance.
Please read these sections carefully.
NOTE:
Amico strongly recommends that alarms be checked annually by qualified staff.
WARNING:
denotes steps which can prevent injury.
CAUTION:
denotes steps which can prevent damage to equipment.
DANGER:
denotes steps which can prevent electrical shock to
equipment or to prevent serious injury and/or death.
IMPORTANT INFORMATION
1. Do not use impact screw driver for installation.
2. When installation is completed, peel off the LCD screen protector.
3. To protect from static electricity, ensure to discharge body static before installing the Medical Gas Alarm.
4. Do not ground the shield drain wire inside the alarm panel back box.
5. Make sure power supply is turned off while wiring.
