www.amico.com 2
Screws
Wall Anchors
Pre-Installation Information (Please Read Carefully Before Starting)
WARNING:
Amico Diagnostic Incorporated is not responsible for the integrity of any mounting
installation. Amico Diagnostic Incorporated recommends that customers contact their
Biomedical Engineering Department or maintenance service to ensure professional installation
for safety and reliability of any mounting accessory.
1. Tape the provided Diagnostic Station outline to wall in the desired location.
2. At 4 locations marked
, drill a 3/16" (4.75 mm) hole to a depth of at least 1.5" (38 mm).
3. Remove Diagnostic Station outline and fully insert anchors into drilled holes.
4. Thread screws into anchors leaving 1/8" (3 mm) of exposed threads.
5. Plug barrel connector of power supply into base station. Cord length can be adjusted by using the
integrated cord wrap on the back of unit.
6. Mount the base station by fitting the holes on the back of the unit over the screw heads. Push
downward on the base station to secure.
Setup
5"
(127 mm)
1-3/8"
(35 mm)
