1
Exergen Thermometer Mount
Quick Installation and Maintenance Instructions
Installation to Mounting Platform Instructions
1. Place the
X-XG-INHLD-BKT
with relevant mounting adapter
ATA/FTA/VTA/PC-125
to the respective
ARS/FRS/VRS/RS RAIL
.
2. Refer to
Figure 1
for installing rail adapter to
EXERGEN 134305/134306/134307/1340308
, and
Figure 2
for installing
RAIL
ADAPTER
to
EXERGEN 134201
.
3. Refer to the “Section 4: Installation on Mounting Platform” of the Barcode Dock Mount manual for instructions on mounting
connecting an adapter to a rail:
• ARS Rail – “Mounting on ARS” under section 4
• FRS Rail – “Mounting on FRS and LRS” under section 4
• VRS Rail – “Mounting on the VRS/Dovetail/Ohmeda Rail” under section 4
• Roll stand 1.25" post - “Mounting on 1.25" Diameter Post” under section 4
If you haven’t received an instruction for your rail system, please contact accessories@amico.com.
Medical Facility Responsibility
Preventive maintenance checks must be performed regularly to maintain the quality and performance of this product. Any parts that
may be broken, missing, worn, distorted, or contaminated in any way should not be used and all affected parts should be replaced
immediately. Should the necessity of any repair be suspected; please contact your local distributor.
!
WARNING:
It is the responsibility of the end user to ensure all aspects of installation are covered by following the full manual
and reviewing warnings/notes.
Installation Tools
Exergen TAT-5000 Wall Mount
#2 Phillips Head Screwdriver
Exergen 134201
Exergen 134305/134307
Exergen 134306 (not shown)
Exergen 134308 (not shown)
#3 Phillips Head Screwdriver
