8
Amico Lighting Solutions
Installing the LightMaster Multifunction Switch
NOTE:
Correct Polarity must be observed in order for the switch to operate. The Master Controller can be severely
damaged by reverse polarity. Ensure that all electrical connections are secured properly and have proper connection.
4.
Connect low voltage output wires from
Master Controller to the keypad using silicone
wire nuts. Each keypad will connect to one
Red one Blue wire provided and labeled in
light fixture. Wiring should be done as per the
wiring diagram provided.
5.
Connect wires for loads and dimmings as per
provided wiring diagram.
6.
Connect two wires from the Master
Controller low voltage output to the top
terminal block on the keypad. (The bottom
terminal block is used for the nurse call
pillow speaker connection only).
