6
Amico Corporation
NOTE:
At this point, it is recommended for the wall to be finished before proceeding. This will minimize
interference of unit with trades, and keep remaining parts clean.
7. Attach the frame and movement assembly that has been removed in
Step 5
to back box using the original hardware
at locations shown. Move frame as necessary to reach all of the hardware..
8. Tighten whiz flange screws using a 5/16" wrench.
IMPORTANT:
The frame has been removed in
Figure 6
to show the parts behind it. Do not remove your frame
from the movement assembly!
Installation
Figure 6
Screw Locations (5)