6
Operating and installation instruction
EPO.D
Picture 5 Flow regulation
9 - regulating valve
15 - spanner
ZW - cold water inlet
By the term "flow regulation" we mean the setting of the water temperature
to a comfortable level, by means of limiting/opening the rate of flow.
For this purpose carry out the following steps:
- set the hot water tap at maximum flow,
- insert the spanner [15] into the regulation valve [9],
- set optimum flow (check if the temperature is comfortable for you) using
the spanner
- take the spanner [15] out of the regulation valve [9],
- close water flow using the tap.
The reccommended maintenance
needs to be repeated each time
after a decay of water.
If the water installation is not
vented the appliance may be
damaged.
1. Cut off electric supply.
2. Open the hot water tap to vent the installation (15-30 seconds).
3. Switch power supply on.
5
Initial start-up
Flow regulation
