8
AmiNET530 Remote Contr
ol Guide
Configuring the remote control
In order for the remote to transmit the correct signals to control the TV/DVD, the remote must be
programmed with a code corresponding to the type of TV in use. Below is a set of instructions for
programming TV codes into the remote. To program DVD codes into the remote repeat the steps
below using the DVD mode button instead of the TV mode button:
• Identify the make of the TV; e.g. Sony, Philips etc.
• Find the TV make in the TV brand code tables in this manual. Most makes of TV have more than
one brand code listed, if this is the case use the steps below to try all the codes until a suitable
one is found. If no brand code exists for your make of TV contact your service provider for help.
• Press the TV Mode button and hold for 2.5 seconds.
The TV button will blink twice.
• Continue to hold down the TV mode button for another 2.5 seconds.
The TV button will blink twice again
• Release TV mode button.
• Enter the 3-digit TV brand code from the list in this manual.
At each key press the mode button will blink.
If the TV brand code is accepted, the TV button will flash twice and go out when the 3rd digit is
entered.
If the TV brand code is not accepted, the TV button will remain illuminated for 2.5 seconds and then
go out. The remote will not have been programmed and the process will have to be repeated from
the start.
During the programming steps if no is button pressed after 10 seconds, the TV button light will go
out, the remote will not have been programmed and the process will have to be repeated from the
start.
If, during programming, the TV button is pressed, the TV button will light for 2.5 seconds and go out.
The remote will not have been programmed and the process will have to be repeated from the start.
Remote Control User Guide 14/11/07 1:36 pm Page 8
