56
6.
Enable
: Check to enable the corresponding QOS rule.
7.
User Rule#
: The QoS rule can work with Scheduling Rule number#. Please refer
to the Section 3.4.1.7 Schedule Rule.
Afterwards, Click on “Save” to store your settings or click “Undo” to give up the
changes.
3.4.4.4.
SNMP
In brief, SNMP, the Simple Network Management Protocol, is a protocol designed to
give a user the capability to remotely manage a computer network by polling and
setting terminal values and monitoring network events.
1.
Enable SNMP
: You must check “Local”, “Remote” or both to enable SNMP
function. If “Local” is checked, this device will respond request from LAN. If
“Remote” is checked, this device will respond request from WAN.
2.
Get Community
: The community of GetRequest is that this device will respond.
3.
Set Community
: The community of SetRequest is that this device will accept.
4.
IP 1, IP 2, IP 3, IP 4
: Enter the IP addresses of your SNMP Management PCs.
User has to configure where this device should send SNMP Trap message.
5.
SNMP Version
: Select proper SNMP Version that your SNMP Management
software supports.
6.
WAN Access IP Address
: If you want to limit the remote SNMP access to
specific computer, please enter the PC’s IP address. The default value is 0.0.0.0,
and it means that any Internet connected computer can get some information of
