Grille Installation:
Align the tabs on the grille with three opening slots on the rim of the enclosure.
The end of the tabs on the grill, when correctly installed, will be slightly above the tile bridge and
between the tile bridge and speaker. The grill will seat flush or level against the ceiling. Any gaps
between the grille and ceiling may indicate that the tab in that area has not ‘snapped’ in place.
Failure to make sure the grill is ‘snapped’ in place could lead to the grill falling out.
Please
DO NOT unfold
the grill tab. Leave the
grill tab as it is and position them on the three
holes in the rim of the speaker can.
To install the grille, gently tap in the grill as
shown above.
Important:
Make sure to test the speakers before installing the grille. The speaker grille may be
difficult to uninstall in some situations.
Painting the Grille:
Use the paint masking card board provided if you need to paint the grille after the installation. Insert
the paint mask between the grille and speaker enclosure then snap the grille.
After the spray paint is done, make sure to take the paint masking card board out by unsnapping the
grille. If needed, use flat screw driver to pop the grille off from the side of the grille. Take the paint
masking board out, and reinstall the grille.
Warranty
The speakers should be not open, altered, tampered without the consulting with AMK, otherwise you
will lose the warranty on the speaker. If the speaker is a need for additional support for seismic
mounting, please consult with AMK.
