Grille Installation:
Align the tabs on the grille with three opening slots on the rim of the enclosure.
The end of the tabs on the grill, when correctly installed, will be slightly above the tile bridge and
between the tile bridge and speaker. The grill will seat flush or level against the ceiling. Any gaps
between the grill and ceiling may indicate that the tab in that area has not ‘snapped’ in place. Failure
to make sure the grill is ‘snapped’ in place could lead to the grill falling out.
Painting the Grille:
Use the paint masking card board provided if you need to paint the grille after the installation. Insert
the paint mask between the grille and speaker enclosure then snap the grille.
After the spray paint is done, make sure to take the paint masking card board out by unsnapping the
grille. If needed, use flat screw driver to pop the grille off from the side of the grille. Take the paint
masking board out, and reinstall the grille.
