Main Active Speaker Wire Connection:
Connect the audio wires connecting active speakers to three passive
speakers through conduit. Pre terminate the wire and connect the Phoenix
plug to the wire. Punch the knockout on the side of the handy box. After
the connection is made, make sure to close the handy box with the cover
provided. The audio wires should be a two conductor wire with
recommended 18 AWG wire.
Connect the Ethernet signal wires through conduit, terminate with RJ45
connector, punch the one of the knock out where RJ45 jack is located, than
plug it into the speaker. After the connection is made, make sure to close
the handy box with the cover provided.
The connection on the top
as shown is to be
connected to same zone
speaker (
Channel 1
) as
the main active PoE
speaker. CONNECTOR
MARKED IN
PINK
COLOR WILL BE THE
SAME CHANNEL AS
ACTIVE SPEAKER
The bottom two connections are
for audio output to two (2)
passive speakers for different
zone (
Channel 2
)
The connection should be
made Cat5 or above cable
for the Ethernet
connection
.
