3.4
Work ing with the tam per
3.4.1
Set ting the work ing height
Set ting the guide bar out of the op ti mal po si tion can in crease
hand/arm vi bra tion.This must be con sid ered when de ter min ing
the ex po sure pe riod.
•
Loosen the screws (1) enough so that the bracket moves up
and down. Do not take them com pletely out.
•
Set the work ing height by turn ing the guide bar (2).
•
Tighten the screws (1).
3.4.2
Ra te of ad van ce
•
The ra te of ad van ce can be in flu en ced in two ways:
-
By chang ing the tilt:
For ward tilt
=
for ward quickly
Rear ward tilt
=
for ward slowly
-
By put ting weight on the gui de bar:
No weight
=
for ward slowly
He avy weight
=
for ward quic kly
02
03
10
00-
2
Hb
m
G
gn
u t
hci
dr
eV
nn
a
m
mA
71
02/
70
3. Ope ra ti on
46
Summary of Contents for ATR 60 C
