3.4.3
Op er a tion
•
The op er a tor's po si tion is in the for ward di rec tion be hind the
ma chine.
•
Set the ac cel er a tor (1) to «
MAX
»; the ma chine works at its
high est fre quency.
•
To get uni form op er at ing per for mance, de pend ing on the
ground con di tion and den sity, set the ac cel er a tor le ver to the
area above the cen trif u gal clutch's op er at ing RPM.
•
In short breaks move the throt tle to «
MIN
»; the ram mer is
idling.
•
For lon ger breaks and af ter work stop the en gine and close
the fuel cock.
02
03
10
00-
2
Hb
m
G
gn
u t
hci
dr
eV
nn
a
m
mA
71
02/
70
If the en gine oil is too low, the en gine won't start.
The dump ing height of the ma te rial to be com pressed
should not be higher than the vi brat ing tam per can
drive over.
Guide the ma chine only with the guide bar, and
don't lift it dur ing op er a tion.
Al ways keep an eye on the ma chine when its en -
gine is run ning.
3. Ope ra ti on
47
Summary of Contents for ATR 60 C
