: 07 3290 4444
: 6/5-15 Lapis St, Underwood
:
sales@ammodoors.com.au
: 07 3290 1614
ABN: 55 147 545 195
:
www.ammodoors.com.au
Coding a Transmitter Button for Pet
(Pedestrian) Mode
1.
Press and hold both the DOOR CODE and MINUS
(-) buttons
(Fig. 29).
2.
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again, or two (2) seconds.
3.
Release " DOOR CODE and MINUS (-) buttons.
4.
Press the transmitter button to test. To change the
default pet (pedestrian) door opening position,
refer Step 2.
Coding transmitter Button to
Enable Vacation mode
The opener can be programmed into a "Vacation Mode"
where the opener will not respond to any transmitter
except one pre-programmed unit.
1.
Press and hold LIGHT CODE and MINUS (-)
Buttons.
2.
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
3.
Release LIGHTCODE and MINUS (-) buttons.
4.
To test, press and hold the transmitter button for
five seconds to set Vacation Mode.
5.
To reset Vacation Mode press the same button
for two seconds.
