Next, the LED switches to the operation ready mode – repeated two red flashes and one green – battery ready for operation – no
receiver on the E/O output.
Once a receiver is connected and found – the E/O output becomes active – the receiver starts being powered.
When a receiver is connected, the LED lights green.
Using a torch with ACCU THERMO battery
It is possible to use ACCU THERMO battery to simultaneously supply power to heated clothing and a torch head. However, such a gear
setup is not recommended for safety reasons.
Ammonite System® recommends diving with a primary torch, independently battery powered, along with two battery powered
backup torches.
Recommendations for use
In the case of a longer period of non-use, the battery capacity must be checked by connecting the charger to the charging socket. If
need be, the battery should be charged up.
The circuit controlling the battery performance is equipped with a microprocessor which consumes little power. Therefore, it is ne-
cessary to check the battery level or – in case of a longer period of non-use – take the pack out of the casing and store separately.
Precautions – Li-Ion battery packs – recommendations
The battery should not be left unattended while being charged.
The battery pack must be fully charged before its first use.
Deep discharge of the pack i.e. one below 8.0 V (15% on the battery display) should be avoided.
The batteries discharge spontaneously even when they are not used. This may result in deep discharge and, consequently, loss of
capacity or deterioration of the battery pack.
Before use in water, condition of the electric cables, particularly the E/O cable, should be checked.
If damage is detected, the battery pack should not be used. The battery should be checked for leaktightness – the plugs and leak
stoppers must be appropriately tightened up.
Ammonite System® company will not be held responsible for any damage resulting from misuse of ACCU THERMO range batteries.
Charging the Li-Ion battery
In order to charge the battery you must connect the charger to a 100–240 V ~ power source.
Proper performance of the charger is indicated on the blue backlit display.
Undo the stopper on the battery terminal labelled „charging/torch”.
The output plug of the charger must be connected to the battery’s „charging/torch” terminal. The charge start is indicated by the
display changing its colour from blue to red and displaying information on the battery pack charge status.
When the battery has been charged, the display will read „FULL 100%”.
Use of the Li-Ion battery:
The battery must be charged only with the AMMO Li-Ion charger supplied by Ammonite System®.
The battery must not be discharged below the voltage level of 8.0 V.
3
