3
Power Connection
The IOT-800 comes with one 2-pin DC terminal block connector to connect power
to DC power connector on the device. To use the block connector:
1.
Use a wire-stripping tool to strip both of the wires from the DC-input
power source. Expose the wire to the appropriate length for the DC power
connector.
2.
Insert the wires into the DC power connector terminals and use a
screwdriver to tighten the two captive screws on the connector.
Pin
Description
1
Power_GND
2
+12V-
3.
Connect the DC terminal block
connector to the power connector
on the IOT-800.
4.
Enable DC power by plugging
in the DC power supply cord to
a power source, or by enabling
power at the designated circuit.
After power connection, toggle the
power switch to
ON
to turn on the
device.
1
2
