INSTALLATION & MAINTENANCE GUIDE
–6–
w w w. a m p l i g h t i n g . c o m
–6–
6
AMP
®
BeaconPro Path & Area Light
APL-3030-4-B-BZ
Reinstall Lens
Place the lens back onto the
bottom of the hat and use the
previously removed screws
to secure. Tighten with a
screwdriver.
Lens
Hat
Screw
7
Install Stake
Determine the desired location
for mounting the stake. Hammer
the stake into the ground until
flange of stake is flush to the
ground. To avoid damage to the
stake, place a board on top of
the stake while hammering.
Note: If the ground is hard and
the stake is difficult to install,
make a crosscut in the ground
using a flat shovel.
Board
Ground
Soil
Stake
