INSTALLATION & MAINTENANCE GUIDE
–4–
w w w. a m p l i g h t i n g . c o m
–4–
Install Lamp
3
Remove Lens
2
customersupport@amplighting.com • 813.978.3900
–5–
Install Lens
4
AMP
®
EquaPro Flood Light
AAL-1014-4-B-BZ
Install Luminaire to Stake
5
Loosen the lens and remove it
from the luminaire.
Luminaire
Lens
Insert the lamp with the correct
wattage and type marked on the
luminaire label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch lamp with bare
hands. Use soft cloth to handle lamp.
NOTE: “Wafer” bi-pin LED lamp also can
be used for this luminaire.
Lamp
“Wafer” Bi-pin
LED Lamp
Socket
Lens
Thread the lens back onto
the luminaire and hand
tighten until snug.
Luminaire
Clear away an area in the ground at
the wireway slot on top of the stake.
Align the wireway slot on the base of
the stake. Lay the luminaire pigtail
into the wireway slot and screw the
luminaire onto the stake. Tighten
until snug to secure the base.
Luminaire
Stake
Pigtail
Wireway Slot
Wire Connection
6
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold seperatley), connect the leads from the luminaire to the main low
voltage supply cable leads.
Pigtail
Main Low Voltage
Supply Cable
Wire Connectors
