customersupport@amplighting.com • 813.978.3900
–5–
INSTALLATION & MAINTENANCE GUIDE
4
AMP
®
G2 ControlPro Series
AAL-102X-4-B-BZ
Remove Glare Guard
Install/Replace Optic
Loosen the set screw and
remove the glare guard from
the fixture.
Glare
Guard
Set Screw
Fixture
5
Remove Fixture Lens
Loosen the fixture lens and remove
it from the fixture.
Fixture Lens
Fixture
6
Remove Fixture Lens
Optic
Screw
Fixture
Loosen the screws and remove the optic
from the fixture.
Install the new optic in the fixture and
reverse Step 3 - Step 1. Make sure that
you have the optic properly aligned over
the LED board before tightening down.
Improper alignment when tightening
the screws can cause the optic to break.
LED Board
