15
4.9.6. Protective shield adjustment
The machine can be ordered with a protective
shield made of transparent plastic material.
Proceed as follows to adjust the protection
s h i e l d :
1. loosen the screw knobs fixing the protection
and lift or lower it at an height of about
6-8 mm from the mouldings to be assembled;
2. tighten knobs to lock the protection shield.
Even if the protective shield is properly
adjusted, it is necessary to respect the
following instructions:
•
keep the fingers away from the frontal and
vertical clamp working area
•
disconnect the pressure supply during any
maintenance intervention
•
keep the foot separated from the pedal during
the machines adjustments
4 . 1 0 OPERATIONS TO BE CHECKED
BEFORE STARTING YOUR WORK
Once the machine has been properly installed
(like previously described), check that:
•
The mouldings to be assembled are properly
positioned on the working bench
•
The magazine is loaded with the type of
nails suitable with the mouldings to be
assembled
•
The adjustment of vertical and horizontal
clamping is correct (chapter 4.9.2 and 4.9.3)
•
The machine is connected to the electric
network,air and the switches are activated
•
The working pressure is adequate to the
wood hardness (see chapter 4.9.5)
•
The protective shield is properly positioned
(see chapter 4.9.6)
•
Press the pedal full down to activate the
machines cycle
Opening the shield causes the control
pedal deactivation.
Summary of Contents for Mitre-Mite VN4 MemoryProgram
