23
5.4.15Machine parameters
The F6 key corresponds to the icon of the
main menu & gives you access to the machine
configuration parameters menu. To access all
functions in this menu you will need the main
installation password.You must call AMP to get
it. After entering into the parameters menu the
icons will change places.
The operator can access only 2 levels of the
parameters corresponding to the F6 icon
& the F5 icon
5.4.15.A.
F5 KEY
The F5 key (corresponding to the icon
is relative to
the CUSTOM parameters.
The access
is possible by:
* 9999 code
The machine code
: A (machine identification
code for serial communication through the RS232
c o n n e c t o r )
The language
can be selected according to the following
codes:
* 0
Italian
* 1
French
* 2
English
* 3
German
Power supply
: power supplying Voltage (%)
Default speed
: proposed speed for programs creation
Homing/ zero any cycle
: input of machine zero point every
time the program is executed (si=yes)
Pedal vertical/horizontal clamping
: pre-disposition of
clamping when the cycle is ended depending from the pedal
(no)
Maintenance:
driver head maintenance position
(100 = 100mm)
V-nails
: Qty of V-nails per strip (200)
V-nails reserve
: minimum Qty of V-nails that
starts the machine alarm (10)
Change speed
: permits you to change the operating
speed while the machine is running (yes)
Frames min/max limit
: these are the min/max
values where the assembly will stop. The max
value refers to the size of programmed frame
Type of frame
: displays the option regarding
the chosen type of frame to count the production
(si= yes)
It is possible at any moment, if the data
should be altered, to restore the typical data
input by the producer, by pressing F1 and
confirming it by pressing ENTER
We suggest: you do not modify the
times relative to the speed if not
assisted by a qualified technician.
The time delays have been calculated
during the machines testing.
5.5 FRAMES PRODUCTION AND V-NAILS
CONSUMPTION
The machine is equipped with a total and daily
V-nail counter.
To access to the counters press the TC button.
The daily V-nail counter can be reset
by pressing the key F1
5.6 TIPS FOR PERFECT JUNCTIONS
a) V-nail types
In order to allow the machine to make excellent
quality junctions using different materials,
it has been necessary to manufacture different
V-nails types for different uses.
V-nails can be classified in three different
g r o u p s :
for soft woods and
soft plastic
Suggested V-nail code SPT
for medium woods
Suggested V-nail code HPT
for hard woods Suggested V-nail code HPT
Daily V-nails
:
XXXX
Total V-nails
: XXXX
Rectangular
: XXXX
Hexagonal
:
XXXX
Octagonal
: XXXX
5.4.15.B F6 key
F6 key
corresponds to the
icon:
speed
parameters; ( access code 1234). It allows you
access to the tables of machine speed/times for
each listed assembling speed.
Note: you can also order v-nails for horizontal grain
MDF Suggested V-Nail Code: HDF
Summary of Contents for Mitre-Mite VN4 MemoryProgram
