Ampcontrol CSM Pty Ltd -
ABN 35 000 770 141
ECD User Manual
Rev 3 – March 2020
ECDB005R0
13/03/2020 13:12
Page
7
of 21
2
RECEIVING AND STORAGE
2.1
Receiving
All possible precautions are taken to protect the equipment against damage or losses during shipment, however before
accepting delivery, check all items against the packing list or bill of loading. If there are shortages or evidence of physical
damage, notify Ampcontrol immediately.
Notify Ampcontrol within 7 days (maximum) in case of shortages or discrepancies, according to the packing list. This action
will
help ensure a speedy resolution to any perceived problems. Keep a record of all claims and correspondence. Photographs are
recommended.
Where practicable do not remove protective covers prior to installation unless there are indications of damage. Boxes opened
for inspection and inventory should be carefully repacked to ensure protection of the contents or else the parts should be
packaged and stored in a safe place. Examine all packing boxes, wrappings and covers for items attached to them, especially
if the wrappings are to be discarded.
2.2
Inspection
Equipment that is found to be damaged or has been modified away from its published specification must not be used. Please
contact Ampcontrol if the equipment is suspected to be different than that ordered or if it does not match the published
specifications.
2.3
Storage after Delivery
When the equipment is not to be installed immediately, proper storage is important to ensure protection of equipment and
validity of warranty.
All equipment should be stored indoors, preferably on shelves and protected from the elements.
2.4
Unpacking of Equipment
The method of packing used will depend on the size and quantity of the equipment. The following cautions should be
interpreted as appropriate.
CAUTION!
Take care when unpacking crates as the contents may have shifted during transport.
The disposal of packaging materials, replaced parts, or components must comply
with environmental restrictions without polluting the soil, air or water.
Ensure that any timber and cardboard used as packaging is disposed of in a safe and
environmentally responsible manner.
Where possible, dispose of all waste products i.e. oils, metals, plastic and rubber
products by using an approved recycling service centre.
Summary of Contents for ECD
Page 22: ...APPENDIX A DRAWINGS ...
Page 24: ...APPENDIX B APPROVALS ...
