ISUPS2B004 Rev 1
Page 32 of 70
Ampcontrol Pty Ltd
– ABN 28 000 915 542
ISUPS 300Wh V2 USER MANUAL
ISUPS2B004 R2
– DEC/17
10.1 Configuration Menu
Press the UP button to select the “Configuration” menu. This menu can be used to View and Modify or
change the configuration settings. To gain access to the configuration menus, a valid password must first
be entered.
6. Configuration
Pressing the RIGHT or ENTER button progresses the display to show the Password entry menu. An
example is shown below:
Enter Password:
>0< * * *
Selection of the first digit of the password is done by progressive pressing of the UP and/or DOWN
button. Pressing the RIGHT button will move to the next digit. Pressing the LEFT button will move to the
preceding digit.
Once the four password digits have been entered, pressing the ENTER button will display the ‘6A: Time
and Date Setup
’ if the password is correct. If the password is not correct, the cursor will return to the left-
most digit of the password entry display. After all the password entry digits are cleared, the password
can be re-entered.
Press the LEFT button to move back to the previous digit or, if in the left-most digit, the previous menu.
NOTE
The correct password must be entered to gain access to the
configuration menus. The factory default password is set to ‘0000’ (four
zeros).
To prevent unsolicited tampering with the configuration settings, it is recommended that the password be
changed once the configuration is completed.
CAUTION!
Be sure to set the new password to a value that is easily remembered
because access cannot be gained to the configuration settings without
the password.
A lost or forgotten password will require returning the unit to Ampcontrol
for resetting.
Refer to Section 10.4 for the Password Management Menu.
The “Configuration” menu has 6-submajor menus that allow access to change the settings belonging to
these categories.
To gain access to the major sub menus, press the UP button while in any of the major submenus,
pressing the RIGHT button will open the submenu and the settings can be changed here.