User and Installation Guide
R
Page 10
Troubleshooting
Problem
Possible Cause
Solution
The transmit light
does not go on after
DC power is applied
to the transmitter
Faulty AC adapter
or faulty power outlet
Check the power outlet and
the AC adapter; if possible,
check for correct voltage of
the AC adapter.
No audio present at
audio input
Check the audio connection
to the transmitter and ensure
that there is audio present.
The transmit light
goes out after a few
seconds and does
not light again
Transmitter hung up
Disconnect and then
reconnect DC power.
Faulty AC adapter
or faulty power outlet
See under “Faulty AC adapter
or faulty power outlet“ above.
Transmitter volume
control set too low
Adjust the transmitter volume
control.
No audio at receiver
Strong interference
See under “Strong
Interference“ on next page.
Transmitter volume
control set too high
Adjust the transmitter volume
control until clipping stops.
Audio is distorted
Strong interference
See under “Strong
Interference“ on next page.
Transmitter volume
control set too low
Adjust the transmitter volume
control to achieve the desired
audio level.
Speaker volume
control set too low
Adjust the speaker volume
control to achieve the desired
audio level.
Speaker audio level
is too low
Audio signal too
weak
Increase the output level of
the audio source (connect
transmitter to an adjustable
output by using an adapter if
necessary).
