Ampler – Stout, Stellar, Curt
29
Before the first ride
Adjusting the saddle height
1. Slightly loosen the seat post clamp on the seat tube with a
4 mm hex key.
2. Move the seat post to the point where the top of the saddle is
approximately at the height of your hip joint.
y
Tighten the seat post clamp.
3. Position the Pedelec in such a way that it is possible to sit on
it and support you (e.g. leaning against a wall).
4. Move one pedal to the lowest possible position.
5. Guide the crank so that it forms a straight line with the seat
tube. Place your heel on the pedal. Your leg should be straight
now with your knee joint still slightly bend.
6. If necessary, loosen the seat post clamp again. Adjust the
saddle height so that the leg is almost extended but not fully
stretched when the heel is on the pedal.
7. Slide the seat post into the seat tube or pull it out if
necessary. Please proceed carefully,
not abruptly
, due to
the internal wiring.
y
Take note of the markings for maximum and minimum
insertion depth.
y
Do not pull out the seat post further than the minimum
insertion mark.
y
Do not push the seat post in further than the safety ring.
8. Check again for the correct height.
9. Tighten the seat post clamp with a 4 mm hex key.
6.2.2 Adjusting the lighting system (light beam of the front light)
The Pedelec's light beam is preset at the factory for proper illumination of the road.
Two TX20 keys are required to adjust the front light (not included; available from specialist shops and tool stores).
Summary of Contents for Curt 2021
