Ampler – Stout, Stellar, Curt
43
Cleaning, maintenance and care
Change tyres (models with belt drive)
Changing tyres on models with belt drive requires a special procedure.
Follow the belt manufacturer's instructions and the safety instructions.
y
The instructions are available on the Ampler Support Portal.
Switch off the Pedelec.
Removing the rear wheel
A video about this is available on the
Ampler Support Portal
. The video explains the necessary assembly
steps in detail and contains further tips.
ATTENTION
Damage is caused to the motor cable and drive by wrong disassembly!
Make sure that the motor cable is disconnected at the rear wheel.
1. Disconnect the motor cable at the plug.
2. Remove the wheel.
3. Remove the tyre from the wheel with a suitable tool.
4. Mount a new tyre.
5. Reinstall the wheel. Keep the following in mind:
6. Bring the rear wheel approximately into position.
7. Place the belt on the front sprocket and then onto the rear sprocket.
8. When the belt is correctly positioned on both sprockets: Insert the rear wheel into the dropouts and tighten the nuts provisionally.
9. Check that the rear wheel is secure and tight in the dropout.
10. Inflate the tyre.
11. Put the wheels on the ground and loosen the rear axle nuts again.
12. Put load on the rear wheel or saddle.
13. The rear wheel is pushed firmly into the dropouts.
14. Tighten the nuts firmly. Pay attention to the tightening torque. Where applicable use a torque wrench.
15. Check the clearance to the mudguard struts.
16. Check that the brakes do not drag.
17. Reconnect the motor cable at the plug.
Changing tyres (on Stout and Stellar models)
J
Only use tyres of the same dimension and with reflective sidewalls.
or
J
When using tyres without reflective sidewalls: Install spoke reflectors.
8.2.8 Screws and nuts
ATTENTION
Damage to bolts and nuts is caused by over-tightening.
Screws and nuts can crack, break or be damaged if they are tightened too much.
Pay attention to the tightening torques.
Tighten bolts and nuts only with suitable tools. Where applicable, use a torque wrench.
J
Check all bolts and nuts on the Pedelec regularly.
y
Tighten any fasteners that are loose or have play. Pay attention to the tightening torques according to the table.
y
If necessary, visit a bicycle workshop to have the cause of loosening fasteners checked out.
Summary of Contents for Curt 2021
