Ampler – Curt
22
Assembly
5.3 Reflectors
Curt requires one white reflector on the front light and a rearward facing red reflector on the seatpost.
The wheels will need to be equipped with two spoke reflectors each.
5.4 Fitting the accessories
5.4.1 Trailer adapter (optional)
Observe and adhere to the maximum permissible load of the trailer according to the manufacturer's instructions.
Observe and adhere to the permissible total weight of the Pedelec with trailer.
Mounting the trailer adapter
1. Remove the nut from the left side of the rear dropout.
y
Do
not
remove the black washer from the dropout: the washer must remain on the axle.
2. Attach the trailer adapter to the axle with a 15 mm spanner.
3. Make sure that the adapter is properly attached.
4. Remove the top screw on the trailer adapter with a 13 mm spanner.
y
Both washers remain as they are on the trailer adapter. The finely notched structure points outwards,
the coarsely notched structures interlock.
5. Install the axle hitch supplied by the trailer manufacturer, together with the set screw, on the trailer adapter.
y
Hold the hitch securely in place while fastening the screw.
Connect trailer to axle hitch
1. Make sure the bike is positioned securely.
2. Connect the trailer to the axle hitch as described in the trailer instructions.
5.4.2 Bike lock (optional)
Follow the instructions for the bicycle lock.
Only attach the bicycle lock to your Pedelec by using the provided holder.
Do
not
allow the bicycle lock to hang loosely on the handlebar, do
not
store or transport it loosely on the rear carrier.
Mounting the holder for the bicycle lock
1. Mount the bicycle lock holder on the eyelets (3 mm hex socket) on the Pedelec according to the manufacturer’s instructions.
2. Insert the bicycle lock into the holder according to the instructions.
3. Ensure that the lock is securely held in place.
