7
V2.3 03.11.20
7
Using the Power Butt on
Just press the power button once on the power panel, located on the
left side of the bike.
Turning the bike on
Charging the bike
State of charge
The battery level is between 40%-90% when you receive it.
You can
either plug in the charger and make the batt ery full, but you can also
grab it out of the box and go.
Charging the bike is like charging a laptop. Just connect the bike with
a standard wall power outlet (110–240 V AC) and hook the magnetic
charger plug to the charging socket located on the power panel and
let it charge. Once the LED on the charger turns from red to green it
has been fully charged. It takes about 2.5 hours from empty to full.
Ampler charger will automatically stop charging when the battery is
full. There is no risk of overcharging the battery when you forget to
unplug it. For your protection, please read carefully “Charger safety
manual” chapter below before operating the Ampler battery charger.
The power button also acts as a battery charge monitor. The LED
colours according to the state of charge.
To turn the lights ON and OFF, hold the power button for 1–2 seconds.
You can turn the lights on/off also from your Ampler mobile app.
The bike will remember the last setting, so the lights will be ON when
you leave them on next time you power the bike.
Turning the lights on
bike is OFF
1x short press
bike is ON
bike is ON
press + hold
front + rear lights
switch ON/OFF
release
74–50%
49–10%
9–0%
100–75%
