Chapter 1
Setting Up the CoreModule 410
2
QuickStart Guide
CoreModule 410
Setup Steps
It is important to follow the setup steps in this section in the exact order listed here, but skip any steps
that do not apply to your situation. References are provided to chapters within this guide or other Ampro
documents for more information about installation and use of the CoreModule 410 CPU Module.
Preparations
1) Open shipping box
•
Locate the QuickStart Kit Contents Sheet
•
Unpack the contents of the shipping box
2) Verify Contents
•
Verify the contents of the shipping box against the QuickStart Contents
Sheet included with your CoreModule 410 CPU Module shipping box.
•
If anything is missing or damaged, call your sales representative or
Tech Support.
CoreModule 410 QuickStart Guide
This hardcopy document describes how to setup, install, and power
up the CoreModule 410 found in the QuickStart Kit and this manual
is also provided as a PDF file on the CoreModule 410
Documentation and Support Software (Doc & SW) CD-ROM.
3) Support Documentation
(CoreModule 410
Documentation and
Support Software (Doc &
SW) CD-ROM)
CoreModule 410 Reference Manual
This document describes the CoreModule 410 and provides detailed
reference information for your CoreModule 410 and is a PDF file
located on the CoreModule 410 Doc & SW CD-ROM.
Setting Up the Workspace
CAUTION
To prevent damage to the electronic components on the CoreModule 410, do not
handle the board until you have followed good Electro-Static Precautions.
Always touch a grounded, unpainted metal surface before touching the
CoreModule 410 or any of the components on the board.
Always use an anti-static wrist strap connected to a grounding mat, which has static-
dissipating characteristics and attached to earth ground.
4) Select workbench location
•
The workbench location should have a static-free mat (or the
equivalent) to place the CoreModule 410 and its cables for setup
and operation (including the connection of the power supply,
peripherals, and support devices).
5) Connect an ESD strap to
your body
•
Connect an ESD strap between your body (wrist or ankle) and ground
or a static-free mat.
If you do not have your own ESD strap, an ESD kit is provided in
the QuickStart Kit with an anti-static wrist strap.
6) Unpack CoreModule 410
•
Remove the CoreModule 410 from its protective plastic case and
place it on a flat static-free work surface.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
