13
point can be saved in one log session. Press the “
LOG
”
button again to exit the data log function.
“CLR ?” Button
The CLR function clears all the saved and logged data in
memory. When the “
CLR
” button is pressed, indicator
“
MEM
” is displayed and the “
CLR
” on upper-right of LCD
will blink. Pressing the “
ENTER
” button printed on the
overlay in white will clear all saved and logged data. Press
“
ESC
” button to exit this function without clearing data.
“REL” Button (Main display)
The relative value function can be used for comparing the
saved reference value with other measurements. Press the
“
REL
” button to store the current measurement as the
reference value, and “
REL
” should be displayed on the
right part of the LCD. The next measurement will display
the current value compared to the reference value. Press
“
REL
” button again to clear the reference value and
deactivate the relative value measurement function.
“APO” Button
Press the “
APO
” button to turn the “
Auto power off
”
function on or off. When this function is enabled, the
indicator “
APO
” is shown at the upper left part of the
LCD.When APO (Auto power off) is enabled, it will
automatically turn the thermometer off no button is
pressed for a period longer than the set time interval (the
default time for APO is 5 minutes). Press power button to
resume operation.
“TYPE” Button (Main display)
Press this key to change the type of thermocouple in the
main display (K/J/T/E/R/S/N). If the inputs of the main and
second display are the same, then pressing this key will
change the thermocouple type for both displays.
