Ampronix AMVX2408, Operation Manual

Warnings

1.  Read the operating manual thoroughly and be familiar with its contents prior to using
     this equipment.
2.  Carefully unpack the unit and check if any damage occurred during shipment.
3.  Should any solid object or liquid fall into the panel, unplug the unit and have it checked
     by qualified personnel before operating it any further.
4.  Uplug the unit if it is not to be used for an extended period of time. To disconnect the
     cord, pull it out by the plug. Never pull the cord itself.
5.  Be a qualified physician, having complete knowledge of the use of this equipment.
6.  Test this equipment prior to a medical procedure. This monitor was fully tested at the
     factory before shipment.
7.  Avoid removing covers on control unit to avoid electric shock.
8.  Attempt no internal repairs or adjustments not specifically detailed in this operating
     manual.
9.  Pay close attention to the care, cleaning instructions in this manual. A deviation may
     cause damage (refer to the Cleaning section).
10. DO NOT STERILIZE MONITOR.
11. Read the entire instruction manual before assembling or connecting the camera.
12. Do not place the monitor or any other heavy object on the power cord. Damage to the
      cable can cause fire or electirc shock.
13. Monitor with power supply is suitable for use in patient environment.
14. DO NOT stack more than 8 boxes high

This equipment has been tested and found to comply with the limits for medical devices
in IEC 601-1-2:2003. These limits are designed to provide reasonable protection against
harmful interference in a typical medical installation.

This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
other devices in the vicinity. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to other
devices, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving device.
- Increase the separation between the equipment.
- Connect the equipment into an outlet on a circuit different from that to which the other
  device(s) are connected.
- Consult the manufacturer or field service technician for help.

NOTICES TO USER

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

FCC WARNING

This equipement generates or uses radio frequency energy.  Changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.

AMVX2408 

5