L0126J
2
On all AMS serial numbers, the first digit identifies where a
merchandiser was manufactured. Those merchandisers built in
the U.S. start with the number
1
. Those merchandisers built in
Mexico start with the number
2
.
The next two digits identify the year of manufacture. These
numbers are
09
(for 2009) and so forth.
The next two digits identify the month. The first month of the year
is
01
and the last month is
12
.
The last four digits identify the number assigned to each
merchandiser during assembly. Numbering starts with
0000
and
continues through
9999
, whereupon these four digits start over.
An example of the numbering system in use is as follows:
1-0902-1156
This merchandiser was manufactured at the Kearneysville, W.V.
plant in 2009, in February, and was the 1156
th
merchandiser
manufactured.
GENERAL SPECIFICATIONS
Operating Environment
AMS vendors are designed for indoor use only. Indoor
temperatures must be between 35°F (1°C) and 110°F (43°C).
The vendor should not be located in an area where it may be
subjected to a water jet or rain.
Cabinet Physical Dimensions:
Model 28
(Refer to Figure 1.2)
28.7”W x 72-3/4”H x 30”D
(73.7 cm x 184 cm x 76.2 cm)
Model 39
(Refer to Figure 1.3)
39.1”W x 72-3/4”H x 35.1”D
(99 cm x 184 cm x 89 cm)
1.3.3 Cabinet Weight:
Model 28:
412 lbs. (187 kg)
Model 39: 488 lbs. (221 kg)
Unit Capacity:
Model 28
Up to 864 Units depending on configuration.
(6 trays, 6 columns, 24/helix)
Model 39
Up to 1440 Units depending on configuration.
(6 trays, 10 columns, 24/helix)
Power Requirements:
United States,
Canada and Mexico:
115 VAC, 60 Hz, 3 Amps
International:
230 VAC, 50/60 Hz, 1.6 Amps
Coin Mechanisms and Bill Validators
AMS vendors will support all Multi-Drop Bus (MDB) coin
mechanisms, bill validators and card readers. Where applicable,
it will also support the “Executive Mechanism” Coin Changer.
1 INTRODUCTION
Summary of Contents for 28 Slim Gem
