DM756 User Guide
Page 13
Magnetic Accessory Coupling
The microscope uses magnetic coupling to attach compatible accessories such as ring lights. This allows accessories to be
quickly attached and detached as needed. Compatible ring lights also draw power through the coupling, allowing them
to be controlled by the multi-function switch.
Ring Lights
Before attaching a ring light, locate the two electrical pins on the top of the ring light, and align them with the two elec
-
trical contacts on the mounting surface of the microscope. It is possible to attach the ring light without proper alignment
of the pins, but the attachment will not receive power. Once the pins are aligned, guide the ring light toward the micro
-
scope’s mounting surface until it snaps in place. The ring light will have a hex screw attached to the outer sleeve. This can
be used to secure the attachment. Using a 1.5mm hex wrench, rotate the screw clockwise until it stops. Overtightening
can result in damage to the screw and surface of the microscope, so avoid applying too much pressure.
The ring-light’s brightness can be controlled by the microscope’s multi-function switch as well as software.
Electrical Pins
Electrical Contacts
