Each AMSEC safe is professionally hand-crafted with quality materials and is equipped with a precision-
quality, digital lock. To become familiar with the lock, operate the lock (as outlined below) several times
before closing the door and locking the safe.
Operating Your Safe
NOTE:
The safe is shipped without the batteries installed. Please use the emergency key (See Step #5)
to open the safe and install the batteries for the first time.
1. SETTINg UP A USER
Open the safe door. (If you have not done so already, use the emergency key to open the door
for the first time and install the 4 AA batteries behind safe door, see Step 5)
With the door open, locate the green programming button. (The green programming button is
located on the hinged side of the door.)
Press the green programming button. The display on the lock should light up saying “Enroll.”
Place your finger on the sensor just under the display. (Use Caution to minimize movement
while programming a finger.) The display should show “Put Again.” Do not move your finger,
just keep it in place. The “Put Again” message indicates it is taking a second scan of your finger.
The display should now show a user number and say, “Enroll OK.” Now you can remove your
finger from the sensor.
If the enrollment fails the display will show “Enroll Again” and try to enroll the finger again.
You can enroll up to 120 users.
ATTENTION:
Before closing the safe door please test your newly enrolled fingerprint. See Step 2 for lock operation.
Please also remove the emergency key from the lock before operating the safe with the biometric reader.
When you remove the emergency key the safe will be locked open.
2. OPENINg THE BIOMETRIC LOCk
Press the Silver button on the front side of the lock, just under the Biometric reader. The
Display will read “Put Finger”
Place your finger on the Biometric sensor. The Display should read “Finger Ok” and then
“Opening” if the fingerprint is validated.
If the biometric sensor reads six (6) consecutive bad finger reads it will lock out the safe for 5
minutes. Please make sure you are enrolled in the safe and are using the finger you used at
time of enrollment to prevent accidental lock out.
3. CLOSINg THE SAFE
Close the door on the safe. If the door is locked open, the safe will need to be unlocked, to
retract the locking bolts. Refer to Step 2, “Opening the Biometric Lock” to open the safe.
Press the Silver button on the front side of the lock, just under Biometric reader. The Display
will read “Closing.” The door should now be locked.
1.
2.
3.
4.
5.
6.
1.
2.
3.
1.
2.
