- 22 -
4.
Push the printhead release lever and
install the label through the media
guide bar, damper, media sensor, and
label guide to install the media.
5.
Move the media sensor by adjusting the media sensor position adjustment knob, make sure the
gap or black mark sensor is at the location where media gap/black mark will pass through for
sensing.
Black mark sensor
(shown as
↓
)
Gap sensor
(shown as
▽
)
6.
Adjust the label guide to fix the media
position.
Note:
* Please install the media through
the media sensor.
* The sensor location is marked by a
triangle mark
▽
(gap sensor) and
arrow mark
↓
(black mark sensor)
at the sensor housing.
* The media sensor position is
adjustable, make sure the gap or
black mark is at the location
where media gap/black mark will
pass through for sensing.
Black mark
sensor
Gap
sensor
Standard Printer Configuration
Internal Rewind Printer Configuration
