AMTC MUAV5860Y-16010, User Manual

SAFETY AND WARNINGS

Step one: Use the expansion 
bolts(4*36PWA) to fix the wall mount 
brackets into the wall

Step Two: Fix the wall mount screws 
(M6x8mm/4pcs) into the rear side of the LCD 
TV,using the tongue 
of 8kgf.cm.

*

The TV appearance subject to material

object.

Step Three: Put the LCD TV with wall mount 
screws onto the wall mount brackets.
Warning: the angle between the TV and wall 
must not be bigger than 3º.

This symbol indicates that this product 
incorporates double insulation between 
hazardous mains voltage and user 
accessible parts. When servicing use only
 identical replacement parts.

This marking indicates that this product 
should not be disposed with other 
household wastes throughout the EU. To 
prevent possible harm to the environment 
or human health from uncontrolled waste 
disposal, recycle it responsibly to promote 
the sustainable reuse of material 
resources. To return your used device, 
please use the return and collection 
systems or contact the retailer where the 
product was purchased. They can take this 
product for environmental safe recycling.

Warning:  Changes or modifications to this unit not 
expressly approved by the party responsible for 
compliance 
                  could void the user’s authority to operate 
the equipment.

NOTE:  This equipment has been tested and found to 
comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules.  

These limits are designed to provide 

reasonable protection against harmful interference in 
a residential installation. 

This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and 
used in accordance
              with the instructions, may cause harmful 
interference to radio communications.

However, there is no guarantee that interference will 
not occur in a particular installation.  If this equipment 
does cause harmful interference 
to radio or television reception, which can be 
determined by turning the equipment off and on, the 
user is encouraged to try to
 correct the interference by one or more of the 
following measures:

o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and 
receiver.
o Connect the equipment into an outlet on a circuit 
different from that to which the        receiver is 
connected.
Consult the dealer or an experienced radio/TV 
technician for help.

This device complies with Part 15 of the FCC Rules.   
Operation is subject to the following two conditions:  
(1) this device may not cause harmful interference, 
and
(2) this device must accept any interference received,
including interference that may cause undesired 
operation.