9. PRESS LH & RH ACTIVATION BUTTONS.
MATERIAL WILL ADVANCE FOR ONE CUT CYCLE
FOR LOAD SEQUENCE.
10. SEE PIC 9.
11. TO RUN: SLIDE KEYPAD SAFETY SHIELD TO
LEFT. PRESS “RUN” KEY.
12. LCD WILL SHOW “LENGTH”, ENTER LENGTH.
TOO LOOSE: MATERIAL WILL NOT BE INDEXED
AND SLIP TOO TIGHT: MATERIAL MAY BE
CRUSHED. MAKE NOTE OF WHEEL POSITION
INDICATOR FOR FUTURE REF.
13. PRESS “ENTER” KEY
14. LCD WILL SHOW “COUNT” ENTER QTY. THEN
PRESS “ENTER” KEY (PIC 13).
15. PRESS “RUN” KEY. SLIDE KEYPAD
SAFETY SHIELD BACK TO RIGHT.
16. REPEAT PROCEDURE AS IN PIC 9 & 10.
MATERIAL WILL THEN BEGIN “RUN” CYLCE.
NOTES:
1. THE LH & RH ACTIVATION BUTTONS ONLY
NEED TO BE PRESSED ONCE AND NOT HELD IN
PLACE DURING “RUN” CYCLE.
2. KEYPAD SAFETY SHIELD MUST BE SLID BACK
TO RIGHT HAND SIDE OF MACHINE DUE TO
SENSOR LOCATION. IF IT IS NOT, THEN THE SLICE
MACHINE WILL NOT PROCEED WITH EITHER
LOAD OR RUN CYCLES.
www.amtiproducts.com
847.588.7090
*SEE MANUAL FOR ALL SAFETY INFORMATION
