9. FEED MATERIAL INTO THE THROAT AND PRESS
LH & RH ACTIVATION BUTTONS. MATERIAL
WILL ADVANCE FOR ONE CUT CYCLE FOR LOAD
SEQUENCE.
10. TO RUN: SLIDE KEYPAD SAFETY SHIELD TO
LEFT. PRESS “RUN”.
11. LCD WILL SHOW “LENGTH”, ENTER LENGTH.
12. PRESS “ENTER”.
13. LCD WILL SHOW “COUNT” ENTER QUANTITY.
THEN PRESS “ENTER”.
14. PRESS “RUN”. SLIDE KEYPAD
SAFETY SHIELD BACK TO RIGHT.
15. PRESS LH & RH ACTIVATION BUTTONS TO
INITIATE PROCESSING.
NOTES:
1. THE LH & RH ACTIVATION BUTTONS
ONLY NEED TO BE PRESSED ONCE AND
NOT HELD IN PLACE DURING “RUN”
CYCLE.
2. KEYPAD SAFETY SHIELD MUST BE SLID
BACK TO RIGHT HAND SIDE OF MACHINE
DUE TO SENSOR LOCATION. IF IT IS NOT,
THEN THE SLICE MACHINE WILL NOT
PROCEED WITH EITHER LOAD OR RUN
CYCLES.
www.amtiproducts.com
847.588.7090
*SEE MANUAL FOR ALL SAFETY INFORMATION
