www.amtren.com
Page 18
FlexWare will prompt you to open one of the drive trays and
place a CD in the disc input.
Press the eject button on the burning drive to open the tray.
Verify that the Installation CD is in the input area and click
the OK button.
The pickarm will swing back and forth. Then the
pickarm will pick up a disc from the disc input,
place it in the open drive tray and then carry it
from the drive tray to the output spindle.
Once the unit has passed these tests, FlexWare
will prompt you to place a blank CD in the disc in-
put. Verify that the blank CD is in the disc input
and click OK on the button shown below to test
the printer.
The pickarm will now open the printer tray, take the disc from the disc input and place it in the open
printer tray. The tray will close and FlexWare will print a simple test pattern on it. The pickarm will then
place the printed disc on the output spindle and close the printer tray.
Click OK on the button above. You are now ready to publish discs using your new automated disc
publishing system! Put the Installation & Support CD in a safe place.