Revised: 12/16/2015
N:\AmTryke\Manuals and Instructions\New Manuals\Manual Docs and Pdf\JT2000
To install the wheel reflectors, place them in an area on the rim behind a single
spoke with two spokes on the
opposite side. Align the front spoke
with the slot in the reflector and
insert the reflector holding pin with
the slotted end going over the
spoke into the hole in the reflector.
Press firmly until you hear it click
into place.
Fitting AmTryke for Rider
JT-2000 has been designed for adults. See the information below for quick
reference on rider’s size requirements:
For more information on how to measure rider’s size correctly, see Rider’s
measurements graphic on page 23.
Follow these instruction to adjust the tryke for rider:
1.
Adjust the seat by moving it forward/back to suit the rider’s needs. When
seated, the rider’s knees should be slightly bent. Tighten the quick release
lever under the seat securely.
2.
Adjust the seat back by moving seat back support rods up/down. Secure
both clevis pins.
3.
Adjust handlebars forward/back and up/down.
If you need further adjustments, see Optional Accessories on the next page for
different options.
JT-2000
Rider’s height: Max. 74 inches
Arm length 20-28 inches
Leg length 30-41 inches
Maximum weight: 250 lbs
NOTE: You may need assistance while fitting the tryke.
Wheel reflector
