Remove the top shroud.
Connecting the elbows and the
tubes. Make sure you attach the
tubes to the elbows first before
you attach the elbows to the
water treatment system.
Connecting to the water
treatment system.
Remove the electronic
module
Push tubing supports into their
respective tubes. Mark a line across
them at the 18mm length.
Position the unit on a flat,
dry surface. Make sure a
power outlet is reachable
within 1.5m.
Fully push the tubes into
the bracket until the mark
on the tubing disappears.
Push in until the mark on
the elbows disappears.
Attention
eSpring Installation & Maintenance Guide
Step 3 : Connecting the tubing
Page 6
Connect to the water treatment system