Installation
7
6" Color Video Touch Panels
Verify the terminal end of the power cable is not connected to a power supply before
plugging in the 2-pin power connector.
5.
Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify the panel is receiving power and functioning properly to prevent
repetition of the installation.
6.
Disconnect the terminal end of the power cable from the connected power supply.
7.
Carefully slide the main unit (
B
in FIG. 5) into the conduit box, so the Mounting Tabs lie flush
against the conduit box (
C
in FIG. 5).
8.
Insert and secure the four securing #4-40 Mounting Screws into their corresponding holes
located along the sides of the AXD(FIG. 5).
9.
Replace the magnetic faceplate (
A
in
FIG. 5) on the main AXD touch panel unit. Make sure
the faceplate is flush against the housing and it is secure.
10.
Reconnect the terminal connectors wiring to their respective locations (
outside the conduit
box
).
11.
Reconnect the terminal power connector on the PS power supply and apply power. The touch
panel beeps when power is applied.
FIG. 5
Wall Mount panel installation configuration for pre-existing conduit/wall box
A
B
- Main AXD unit consists of
C
- Optional CB-CV6
- Decor
faceplate
Install the (2) #4-40
screws into the places
indicated
Removable
tabs used to
the touch panel and backbox housing
conduit/wallbox
Cable
knockouts
mount the box
to a stud beam
Installed flush
against a solid
surface
Do not
use these
Mounting tabs to
mount the
conduit /wallbox
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the conduit box.
