Installation
11
6" Color Video Touch Panels
2.
Cut out the install surface using the dimensions shown in FIG. 11. Be sure to cut out the two
notches along the side of the CV6 to accommodate the two provided drywall expansion clips.
3.
Thread the incoming AXlink wiring through the cutout in the wall.
4.
Disconnect the AXlink connector from the Central Controller and thread the terminal end of
the 4-pin AXlink cable through the circular cutout provided on the wallbox.
FIG. 10
Wall Mount panel installation configuration for drywall surfaces
A
B
- Main AXD unit consists of
- Decor
faceplate
Install the 2 drywall
clips and screws
(included) into the
holes
Flat surface
(can include a
the touch panel and housing
wall, podium, or
other level
surface)
2 notches are
required if the unit
is installed in
drywall using the (2)
provided clips
The drywall clip set must be re-ordered from AMX if the drywall clip is bent
accidentally during an installation or removed during a re-installation.
FIG. 11
Wall Mount panel installation configuration for plasterboard
.30
2.45
2.09
4.37
5.37
[62.2 MM]
[53.1 MM]
MAX
[136.5 MM]
[110.9 MM]
[7.6 MM]
WALL
(CUTOUT)
ZERO RADIUS
TYP. ALL CORNERS.
.140 DIA HOLES
2.900
.12
.76
(BEZEL)
5.97
6.21
6.79
CUTOUT
1.71
4.43
.25 TYP
1.00
5.37
(BEZEL)
.28 REF
Front view
Side view