Installation
4
6" Color Video Wall Panel
7.
Verify that the panel is receiving power and functioning properly. This should be done to
prevent repetition of the installation.
8.
Disconnect the AXlink connector from the Central Controller until the installation of the panel
is complete.
9.
Connect the data and power wiring to the rear of the touch panel.
10.
Fasten the BB-CV6 to the stud through the tabs shown in FIG. 3. The wallbox can be secured
to the stud by using either nails or screws. This installation must be done prior to any wall
installation.
11.
Slide the main unit (
B
in FIG. 2) into the conduit/wallbox (
C
in FIG. 2) until it slides in
completely and flush against the wallbox.
12.
Use the securing machine #4-40 screws (four provided) to attach the main AXD unit to the
wall box. The screws fit in the indicated holes on the main unit (FIG. 2).
13.
Place the magnetic faceplate (
A
in
FIG. 2) on the main touch panel unit. Make sure the
faceplate is flush against the housing and it is secure.
14.
Reconnect the AXlink wiring to the Central Controller. The touch panel beeps when power is
applied.
Mounting the Decor-style panel on a flat or solid surface
To install Decor-style touch panels:
1.
Remove the magnetically attached Decor faceplate (
A
in FIG. 4
)
from the main AXD unit
(
B
in FIG. 4) by gripping the faceplate and pulling with gentle force.
2.
Cut out the surface using the dimensions shown in FIG. 5. Be sure not to cut out notches for the
expansion clips (only used when mounting the panel in plasterboard). FIG. 6 shows a sample
of the CV6 (
62-5924-06
) cutout template used for an accurate visual reference of the cutout
dimensions.
3.
Thread the incoming AXlink wiring through the cutout on the flat surface.
4.
Disconnect the AXlink connector from the Central Controller and thread the terminal end of
the 4-pin AXlink cable through the circular cable knockouts provided on the wallbox.
5.
Attach the data and power wiring to the touch panel.
FIG. 3
Screw location for attachment of the BB-CV6 in a typical drywall installation
Sheet
rock
Stud
Tabs may be removed if not used for the installation
BB-CV6 Conduit Wallbox
TYPICAL DRYWALL INSTALLATION