Pre-Installation
7
PC Presenter
Pre-Installation
Setting the TXC-MS(L) transmitter DIP switch
The TXC-MS(L) transmitter transmits IR or RF signals, according to how you set position 1 on the
8-position DIP switch. The DIP switch is located under the battery cover, on the back of the
TXC-MS(L), as shown in FIG. 6. To open the battery compartment, slide the cover down and
remove.
FIG. 7 shows the eight-position transmitter DIP switch.
IR and RF Settings
The transmitter can be configured for either IR or RF, but not both. DIP switch position 1 sets the
transmitter for IR or RF, as shown in FIG. 8.
Set position 1 to Off (down) for IR.
Set position 1 to On (up) for RF.
FIG. 6
Location of 8-position DIP switch and battery compartment locations
FIG. 7
Eight-position transmitter DIP switch
FIG. 8
DIP switch settings for IR and RF modes
8-position DIP switch
Battery compartment
DIP switches
DIP switch #1
sets IR or RF
transmission
#2 - 4 are not used
DIP switches
#5 - 8 set the radio
code of the transmitter
IR mode
RF mode
